Cisco IOS Voice, Video, and Fax Commands: R Through Sh
show call history
Table 28 show call history Field Descriptions (continued)
Field | Description |
|
|
Modem passthrough | Indicates that this is a modem |
signaling method is nse | events |
| signaling codec upspeed. The upspeed method is the method used to |
| dynamically change the codec type and speed to meet network |
| conditions. This means that you might move to a faster codec when you |
| have both voice and data calls and then slow down when there is only |
| voice traffic. |
|
|
NoiseLevel | Average noise level for this call. |
|
|
OnTimeRvPlayout | Duration of voice playout from data received on time for this call. |
| Derive the Total Voice Playout Duration for Active Voice by adding the |
| OnTimeRvPlayout value to the GapFill values. |
|
|
Percent Packet Loss | Total percent packet loss. |
|
|
PeerAddress | Destination pattern or number associated with this peer. |
|
|
PeerId | ID value of the peer entry table to which this call was made. |
|
|
PeerIfIndex | Voice port index number for this peer. For ISDN media, this would be |
| the index number of the B channel used for this call. |
|
|
PeerSubAddress | Subaddress where this call is connected. |
|
|
ReceiveBytes | Number of bytes received by the peer during this call. |
|
|
ReceiveDelay | Average Playout FIFO Delay plus the Decoder Delay during this voice |
| call. |
|
|
ReceivePackets | Number of packets received by this peer during this call. |
|
|
RemoteIPAddress | Remote system IP address for this call. |
|
|
RemoteUDPPort | Remote system UDP listener port to which voice packets are sent. |
|
|
RoundTripDelay | Voice packet |
| the IP backbone for this call. |
|
|
SelectedQoS | Selected RSVP QoS for this call. |
|
|
Session Protocol | Session protocol used for an Internet call between the local and remote |
| router through the IP backbone. |
|
|
Session Target | Session target of the peer used for this call. |
|
|
SetUpTime | Value of the system UpTime when the call associated with this entry was |
| started. |
|
|
SignalingType | Signaling type for this call, for example, |
| (CAS) or |
|
|
Time between Buffer | Minimum and maximum durations between jitter buffer drain or fill |
Drain/Fills | events, in seconds. |
|
|
TransmitBytes | Number of bytes sent by this peer during this call. |
|
|
TransmitPackets | Number of packets sent by this peer during this call. |
|
|
TxDuration | Duration of the transmit path open from this peer to the voice gateway |
| for this call. |
|
|
Cisco IOS Voice, Video, Fax Command Reference
