Cisco Systems VR-561 Session target VoATM, Cisco 3600 Series Routers Voice over ATM Dial Peers

Cisco IOS Voice, Video, and Fax Commands: R Through Sh

session target (VoATM)

session target (VoATM)

To specify a network-specific address for a specified VoATM dial peer, use the session target command in dial-peer configuration mode. To restore default values for this parameter, use the no form of this command.

Cisco 3600 Series Routers Voice over ATM Dial Peers

session target interface pvc {name vpi/vci vci}

no session target

Cisco MC3810 Multiservice Concentrator Voice over ATM Dial Peers

session target {serial atm} interface pvc {word vpi/vci vci} cid

	no session target
Syntax Description	serial	Specifies the serial interface for the dial-peer address.
	atm	Specifies the ATM interface. The only valid number is 0.
	interface	Interface type and interface number on the router.
	pvc	The specific ATM permanent virtual circuit (PVC) for this dial peer.
	word	(Optional) A name that identifies the PVC. The argument can identify
		the PVC if a word identifier was assigned when the PVC was created.
	name	The PVC name.
	vpi/vci	ATM network virtual path identifier (VPI) and virtual channel
		identifier (VCI) of this PVC.
		On the Cisco 3600, if you have the Multiport T1/E1 ATM network
		module with IMA installed, the valid range for vpi is from 0 to 5, and
		the valid range for vci is from 1 to 255.
		If you have the OC3 ATM Network Module installed, the valid range
		for vpi is from 0 to 15, and the valid range for vci is from 1 to 1023.
	vci	ATM network virtual channel identifier (VCI) of this PVC.
	cid	ATM network channel identifier (CID) of this PVC. The valid range
		is from 8 to 255.
Defaults	The default for this command is enabled with no IP address or domain name defined.
Command Modes	Dial-peer configuration

Cisco IOS Voice, Video, Fax Command Reference

VR-607