Cisco Systems VR-561 VR-713

Cisco IOS Voice, Video, and Fax Commands: R Through Sh show dialplan incall number

VR-713

Cisco IOS Voice, Video, Fax Command Reference

Examples The following example shows that an incoming call from interface 1/0/0:D with a calling number of 12345 is matched to POTS dial peer 10:

Router# show dialplan incall 1/0/0:D number 12345

Macro Exp.: 12345

VoiceEncapPeer10

information type = voice,

tag = 10, destination-pattern = `123..',

answer-address = `', preference=0,

numbering Type = `unknown'

group = 10, Admin state is up, Operation state is up,

incoming called-number = `', connections/maximum = 0/unlimited,

DTMF Relay = disabled,

huntstop = disabled,

in bound application associated: DEFAULT

out bound application associated:

permission :both

incoming COR list:maximum capability

outgoing COR list:minimum requirement

type = pots, prefix = `',

forward-digits default

session-target = `', voice-port = `1/0/0:D',

direct-inward-dial = disabled,

digit_strip = enabled,

Connect Time = 0, Charged Units = 0,

Successful Calls = 0, Failed Calls = 0,

Accepted Calls = 0, Refused Calls = 0,

Last Disconnect Cause is "",

Last Disconnect Text is "",

Last Setup Time = 0.

Matched: 12345 Digits: 3

Target:

The following example shows that if no dial peer has a destination pattern or answer address that matches the calling number of 888, the incoming call is matched to POTS dial peer 99, because the call comes in on voice port 1/0/1:D, which is the voice port configured for this dial peer:

Router# show dialplan incall 1/0/1:D number 888

Macro Exp.: 888

VoiceEncapPeer99

information type = voice,

tag = 99, destination-pattern = `99...',

answer-address = `', preference=1,

numbering Type = `national'

group = 99, Admin state is up, Operation state is up,