Cisco IOS Voice, Video, and Fax Commands: R Through Sh show interface dspfarm
VR-737
Cisco IOS Voice, Video, Fax Command Reference
show interface dspfarm
To display digital signal processor (DSP) information on the two-port T1/E1 high-density port adapter
for the Cisco 7200 series, use the show interface dspfarm command in privileged EXEC mode.
show interface dspfarm [slot/port]
Syntax Description
Defaults No default behavior or values.
Command Modes Privileged EXEC
Command History
Usage Guidelines The local time-division multiplexing (TDM) cross-connect map can be displayed.
Examples The following example is sample output from the show interface dspfarm command for port adapter
slot 0 of chassis slot 3, on the Cisco 7200 series router:
Router# show interface dspfarm 3/0
DSPfarm3/0 is up, line protocol is up
Hardware is VXC-2T1/E1
MTU 256 bytes, BW 12000 Kbit, DLY 0 usec,
reliability 255/255, txload 4/255, rxload 1/255
Encapsulation VOICE, loopback not set
C549 DSP Firmware Version:MajorRelease.MinorRelease (BuildNumber)
DSP Boot Loader:255.255 (255)
DSP Application:4.0 (3)
Medium Complexity Application:3.2 (5)
High Complexity Application:3.2 (5)
Total DSPs 30, DSP0-DSP29, Jukebox DSP id 30
Down DSPs:none
Total sig channels 120 used 24, total voice channels 120 used 0
0 active calls, 0 max active calls, 0 total calls
30887 rx packets, 0 rx drops, 30921 tx packets, 0 tx frags
0 curr_dsp_tx_queued, 29 max_dsp_tx_queued
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy:fifo
Output queue 0/0, 0 drops; input queue 0/75, 0 drops
5 minute input rate 13000 bits/sec, 94 packets/sec
5 minute output rate 193000 bits/sec, 94 packets/sec
slot (Optional) Slot location of the port adapter.
/port (Optional) Port number on the port adapter.
Release Modification
12.0(5)XE This command was introduced on the Cisco7200 series router.
12.1(1)T This command was integrated into the Cisco IOS 12.1(1)T.