Cisco Systems VR-561 manual Show ss7 mtp2 timer channel, VR-804

Cisco IOS Voice, Video, and Fax Commands: R Through Sh

show ss7 mtp2 timer

show ss7 mtp2 timer

Note

Syntax Description

Defaults

To display durations of the SS7 MTP 2 state machine timers, use the show ss7 mtp2 timer command in privileged EXEC mode.

show ss7 mtp2 timer [channel]

The eight timers whose status is displayed using the show ss7 mtp2 timer command are set on the Media Gateway Controller using MML commands. The timers are then downloaded from the controller to the Cisco SLT.

channel Specifies a channel from 0 through 3.

If you do not specify a channel, the command shows status information for channel 0.

Command Modes

Command History

Privileged EXEC

Release	Modification
12.0(7)XR	This command was introduced.
12.1(1)T	This command was integrated into Cisco IOS
	Release 12.1(1)T.

Usage Guidelines MTP 2 uses eight different timers on each link. Throughout the link state transitions, multiple timers are active. An in-service MTP 2 link requires timers that are constantly started, stopped, and restarted. Use this command to display the configured timer durations.

Note All MTP 2 configuration parameters are set at the Cisco SLT command line interface. The Media Gateway Controller parameter data files are no longer used to configure the Cisco SLT.

Cisco IOS Voice, Video, Fax Command Reference

VR-804