Cisco IOS Voice, Video, and Fax Commands: R Through Sh

sgcp tse payload

sgcp tse payload

To enable Inband Telephony Signaling Events (TSE) for fax and modem operation, use the sgcp tse payload command in global configuration mode. To restore the default value, use the no form of this command.

sgcp tse payload type no sgcp tse payload type

Syntax Description

type

Sets the TSE payload type. The valid range is from 96 to 119. The

 

 

default is 0, meaning that the command is disabled.

 

 

 

Defaults

Command Modes

Command History

Zero (0)

Global configuration

Release

Modification

12.0(7)XK

This command was introduced on the Cisco MC3810 multiservice

 

concentrator and Cisco 3600 series routers (except the Cisco 3620) in a

 

private release that was not generally available.

 

 

12.1(2)T

This command was integrated into 12.1(2)T and was generally available

 

on the Cisco 3600 series router and the Cisco MC3810 multiservice

 

concentrator

 

 

Usage Guidelines

Examples

Because this command is disabled by default, you must specify a TSE payload type.

If you configure the sgcp modem passthru command to the nse value, then you must configure this command.

The following example shows the Simple Gateway Control Protocol (SGCP) modem pass-through set using the NSE-based modem upspeed and the Inband Telephony Signaling Events payload value set to 110:

sgcp modem passthru nse sgcp tse payload 110

Related Commands

Command

Description

 

sgcp

Starts and allocates resources for the SGCP daemon.

 

 

 

 

sgcp call-agent

Defines the IP address of the default SGCP call agent.

 

 

 

 

sgcp graceful-shutdown

Gracefully terminates all SGCP activity.

 

 

 

Cisco IOS Voice, Video, Fax Command Reference

VR-645

Page 85
Image 85
Cisco Systems VR-561 manual Sgcp tse payload type no sgcp tse payload type, Zero Global configuration, VR-645