Cisco Systems VR-561 manual VR-717, Router# show dialplan number 1001 huntstop

Cisco IOS Voice, Video, and Fax Commands: R Through Sh

show dialplan number

direct-inward-dial = disabled, Connect Time = 0, Charged Units = 0,

Successful Calls		= 0, Failed Calls = 0, Incomplete Calls = 0
Accepted Calls =		0, Refused Calls = 0,
Last Disconnect Cause is "",
Last Disconnect Text is "",
Last Setup Time = 0.
Matched: 1001	Digits: 4
Target:
VoiceEncapPeer1004
information type		= voice,
tag = 1004, destination-pattern = `1001',
answer-address =		`', preference=0,
numbering Type =		`unknown'
group = 1004, Admin state is up, Operation state is up,
...
Matched: 1001	Digits: 4
Target:
VoiceEncapPeer1002
information type		= voice,
tag = 1002, destination-pattern = `1001',
answer-address =		`', preference=0,
numbering Type =		`unknown'
group = 1002, Admin state is up, Operation state is up,
...
Matched: 1001	Digits: 4
Target:
VoiceEncapPeer1001
information type		= voice,
tag = 1001, destination-pattern = `1001',
answer-address =		`', preference=0,
numbering Type =		`unknown'
group = 1001, Admin state is up, Operation state is up,
...
Matched: 1001	Digits: 4
Target:

The following example shows sample output from the show dialplan number command using the destination pattern of 1001 and the huntstop keyword:

Router# show dialplan number 1001 huntstop

Macro Exp.: 1001

VoiceEncapPeer1003

information type = voice,

tag = 1003, destination-pattern = `1001', answer-address = `', preference=0, numbering Type = `unknown'

group = 1003, Admin state is up, Operation state is up, incoming called-number = `', connections/maximum = 0/unlimited, DTMF Relay = disabled,

huntstop = enabled,

type = pots, prefix = `', forward-digits default session-target = `', voice-port = `1/1', direct-inward-dial = disabled,

Connect Time = 0, Charged Units = 0,

Successful Calls = 0, Failed Calls = 0, Incomplete Calls = 0 Accepted Calls = 0, Refused Calls = 0,

Last Disconnect Cause is "",

Cisco IOS Voice, Video, Fax Command Reference

VR-717