Cisco Systems VR-561 manual Incoming-called number command, VR-711

Cisco IOS Voice, Video, and Fax Commands: R Through Sh

show dial-peer voice

Table 35 show dial-peer voice Field Descriptions (continued)

	Field	Description
	huntstop	Indicates whether dial-peer hunting has been turned on, by using the
		huntstop command, for this dial peer.
	Icpif	Configured Calculated Planning Impairment Factor (ICPIF) value for
		calls sent by a dial peer.
	incall-number	Full E.164 telephone number to be used to identify the dial peer.
	incoming called-number	Indicates the incoming called number if it has been set by using the
		incoming-called number command.
	information type	Information type for this call; for example, voice or fax.
	Last Disconnect Cause	Encoded network cause associated with the last call. This value will be
		updated whenever a call is started or cleared and depends on the
		interface type and session protocol being used on this interface.
	Last Disconnect Text	ASCII text describing the reason for the last call termination.
	Last Setup Time	Value of the System Up Time when the last call to this peer was started.
	Modem passthrough	Modem pass-through signaling method is named signaling event (NSE).
	Operation state	Operational state of this peer.
	Payload type	NSE payload type.
	Permission	Configured permission level for this peer.
	Poor QOV Trap	Whether Poor Quality of Voice trap messages have been enabled or
		disabled.
	Redundancy	Packet redundancy (RFC 2198) for modem traffic.
	Refused Calls	Number of calls from this peer refused since system startup.
	req-qos	Configured requested quality of service for calls for this dial peer.
	session-target	Session target of this peer.
	sess-proto	Session protocol to be used for Internet calls between local and remote
		routers through the IP backbone.
	Successful Calls	Number of completed calls to this peer.
	tag	Unique dial peer ID number.
	VAD	Whether voice activation detection (VAD) is enabled for this dial peer.
Related Commands	Command	Description
	show call active voice	Displays the Voice over IP active call table.
	show call history voice	Displays the Voice over IP call history table.
	show num-exp	Displays how the number expansions are configured in Voice over IP.
	show voice port	Displays configuration information about a specific voice port.

Cisco IOS Voice, Video, Fax Command Reference

VR-711