Cisco IOS Voice, Video, and Fax Commands: R Through Sh
show call active
Tele <int>: tx:<tot>/<v>/<fax>ms <codec> noise:<l> acom:<l> i/o:<l>/<l> dBm
1: 22021hs.1 +2263 pid:0 Answer wook song active tx:0/0 rx:0/41190
IP 0.0.0.0 AcceptedMime:2 DiscardedMime:1
1: 23193hs.1 +1091 pid:3469 Originate 527.... active tx:10/13838 rx:0/0
Tele : tx:31200/10910/20290ms
Table 27 provides an alphabetical listing of the fields displayed in the output from the show call active command and a description of each field.
Table 27 show call active Field Descriptions
Field | Description |
|
|
ACOM Level | Current ACOM level for this call. ACOM is the combined loss achieved |
| by the echo canceler, which is the sum of the Echo Return Loss, Echo |
| Return Loss Enhancement, and nonlinear processing loss for the call. |
|
|
Buffer Drain Events | Total number of jitter buffer drain events. |
|
|
Buffer Fill Events | Total number of jitter buffer fill events. |
|
|
CallDuration | Length of the call in hours, minutes, and seconds, hh:mm:ss. |
|
|
CallOrigin | Call origin: answer or originate. |
|
|
CallState | Current state of the call. |
|
|
ChargedUnits | Total number of charging units that apply to this peer since system |
| startup. The unit of measure for this field is hundredths of second. |
|
|
CodecBytes | Payload size in bytes for the codec used. |
|
|
CoderTypeRate | Negotiated coder rate. This value specifies the send rate of voice or fax |
| compression to its associated call leg for this call. |
|
|
ConnectionId | Global call identifier for this gateway call. |
|
|
ConnectTime | Time at which the call was connected. |
|
|
Total number of consecutive (two or more) | |
Events |
|
|
|
Corrected | Total number of packet loss events that were corrected using the |
Events | RFC 2198 method. |
|
|
Tag of the dial peer sending this call. | |
|
|
ERLLevel | Current Echo Return Loss (ERL) level for this call. |
|
|
FaxTxDuration | Duration of fax transmission from this peer to the voice gateway for this |
| call. You can derive the Fax Utilization Rate by dividing the |
| FaxTxDuration value by the TxDuration value. |
|
|
GapFillWithInterpolation | Duration of a voice signal played out with a signal synthesized from |
| parameters, or samples of data preceding and following in time because |
| voice data was lost or not received in time from the voice gateway for this |
| call. |
|
|
GapFillWithRedundancy | Duration of a voice signal played out with a signal synthesized from |
| available redundancy parameters because voice data was lost or not |
| received in time from the voice gateway for this call. |
|
|
Cisco IOS Voice, Video, Fax Command Reference
