Cisco Systems VR-561 manual Session protocol Voice over Frame Relay, Frf11-trunk, VR-603

Cisco IOS Voice, Video, and Fax Commands: R Through Sh

session protocol (Voice over Frame Relay)

session protocol (Voice over Frame Relay)

Syntax Description

Defaults

Command Modes

Command History

To establish a Voice over Frame Relay protocol for calls between the local and remote routers via the packet network, use the session protocol command in dial-peer configuration mode. To reset the default value, use the no form of this command.

session protocol {cisco-switched frf11-trunk}

no session protocol

cisco-switched	Specifies proprietary Cisco VoFR session protocol. (This is the only valid
	session protocol for the Cisco 7200 series.)
frf11-trunk	Specifies FRF.11 session protocol.
cisco-switched
Dial-peer configuration
Release	Modification
11.3(1)T	This command was introduced for VoIP.
12.0(3)XG	This command was modified to support VoFR on the Cisco 2600, 3600, and
	7200 series routers and the Cisco MC3810 multiservice concentrator.
12.0(4)T	The cisco-switchedand frf11-trunkkeywords were added for VoFR dial
	peers.

Usage Guidelines	For Cisco-to-Cisco dial peer connections, Cisco recommends that you use the default session protocol
	because of the advantages it offers over a pure FRF.11 implementation. When connecting to
	FRF.11-compliant equipment from other vendors, use the FRF.11session protocol.
Note	When using the FRF.11 session protocol on Cisco 2600 series and 3600 series routers, you must also
	use the called-numbercommand.
Examples	The following example shows how to configure the FRF.11 session protocol on a Cisco 2600 series or
	3600 series router for VoFR dial peer 200:
	dial-peer voice 200 vofr
		session protocol frf11-trunk
		called-number 5552150
	The following example shows how to configure the FRF.11 session protocol on a Cisco MC3810
	multiservice concentrator for VoFR dial peer 200:
	dial-peer voice 200 vofr
		session protocol frf11-trunk
		Cisco IOS Voice, Video, Fax Command Reference

VR-603