Cisco IOS Voice, Video, and Fax Commands: R Through Sh
show voice port
0:21 | 22 | up | dorm idle | y | ||
0:22 | 23 | up | dorm idle | y | ||
0:23 | 24 | up | dorm idle | idle | y | |
1/1 | up | dorm | idle | y | ||
1/2 | up | dorm | idle | y | ||
1/3 | up | dorm idle | idle | y | ||
1/4 | up | dorm idle | idle | y | ||
1/5 | up | dorm idle | y | |||
1/6 | up | dorm idle | y | |||
Elements : |
|
sys/voip/ccvpm | vpm_htsp.c (107) |
sys/voip/ccvtsp | vtsp_core.c (167) |
sys/voip/cli | voiceport_action.c (58) |
receEive and transMit Slot is 1,
Operation State is DORMANT Administrative State is UP No Interface Down Failure Description is not set Noise Regeneration is enabled
Non Linear Processing is enabled
Music On Hold Threshold is Set to
Out Attenuation is Set to 0 dB Echo Cancellation is enabled
Echo Cancel Coverage is set to 8 ms Connection Mode is normal Connection Number is not set Initial Time Out is set to 10 s Interdigit Time Out is set to 10 s Region Tone is set for US
The following is sample output from the show voice port command for an E&M analog voice port on a Cisco 3600:
E&M Slot is 1,
Type of VoicePort is E&M
Operation State is unknown
Administrative State is unknown
The Interface Down Failure Cause is 0
Alias is NULL
Noise Regeneration is disabled
Non Linear Processing is disabled
Music On Hold Threshold is Set to 0 dBm
In Gain is Set to 0 dB
Out Attenuation is Set to 0 dB
Echo Cancellation is disabled
Echo Cancel Coverage is set to 16ms
Connection Mode is Normal
Connection Number is
Initial Time Out is set to 0 s
Interdigit Time Out is set to 0 s
Analog Info Follows:
Region Tone is set for northamerica
Currently processing none
Maintenance Mode Set to None (not in mtc mode)
Number of signaling protocol errors are 0
Voice card specific Info Follows:
Signal Type is
Operation Type is
Impedance is set to 600r Ohm
E&M Type is unknown
Cisco IOS Voice, Video, Fax Command Reference
