HP 5961-0509 manual Being the current pen location, Upper right corner 2500 plu to the right

Table 22-6 Example: Using the FT Command (continued)

PA2000,2000;	Specify absolute plotting and move to
	location (2000,2000).
FT;RR2500,300;	Select the default fill type (solid black); fill
ER2500,300;	a rectangle using solid black fill, with the
	lower left corner being the current pen
	location and the upper right corner a point
	2500 plu to the right and 300 plu up; edge
	the rectangle that was just filled.
PR0,300;FT3,80,30	Specify relative plotting and move the
; RR2500,300;	pen up 300 plu; select fill type number 3
	(parallel lines), with 80 plu between each
	line, with each line tipped 30×; fill a
	rectangle with the just-specified fill, using
	the rectangle bounded at the lower left
	corner by current the pen location and a
	point 2500 X-units and 300 Y-units away
	as the upper right corner.
PR0,300;FT10,36;	Move the pen position up 300 plu; specify
RR2500,300;	the fill type as 36% shading; fill a rectangle
ER2500,300;	with 36% shading, with the lower left corner
	being the current pen location and the
	upper right corner 2500 plu to the right
	and 300 plu up from there; edge the outline
	of the same rectangle.
?%0A	Enter the PCL mode.
?E	Send a reset to end the job and eject the
	page.

Figure 22-10

22-14The Line and Fill Attributes Group EN