HP 5961-0509 manual Small circle dot, and specify, Label origin number, 23-64The Character Group

Table 23-34 Example: Using the LO Command (continued)

SI.17,.26;PA0,500;	Set the absolute character
	size to .17 cm wide by .26 cm
	high; move to (0,500).
PD-500,0,0,-500,	Set the pen down and draw
500,0,0,500;	lines from (0,500) to (-500,0),
	to (0,-500), to (500,0), and
	then to (0,500).
DT#;	Define label terminator as “#”
	character.
CI10;LO4; LBCentered on point#;	Draw a small circle (radius –
	10 plu) to represent the label
	origin point, specify a label
	origin of 4, and print
	“Centered on point.”
PU-500,0;CI10; LO18;	Lift the pen and move to
	(-500,0), draw another small
	circle, and specify a label
	origin of 18.
LBLeft center offset#;	Print “Left center offset.”
PU0,-500;CI10; LO13;	Lift the pen, draw another
	small circle, and specify label
	origin number 13.
LBRight offset from point#;	Print “Right offset from point.”
PA500,0;CI10;LO3;	Move to (500,0), draw another
	small circle (dot), and specify
	label origin number 3.
LBRight hang from point#;	Print the last label, “Right
	hang from point”.
EC%0A	Enter the PCL mode.
ECE	Send a reset to end the job
	and eject the page.

23-64The Character Group EN