HP 6200 manual To extend your phone cord, Am having problems faxing over the Internet Solution

Chapter 15

The phone cord that came with my HP all-in-one is not long enough

Solution

If the phone cord that came with your HP all-in-one is not long enough, you can use a coupler to extend the length. You can purchase a coupler at an electronics store that carries phone accessories. You will also need another phone cord, which can be a standard 4-wire phone cord that you might already have in your home or office.

Tip If your HP all-in-one came with a 2-wire phone cord adaptor, you can use it with a 4-wire phone cord to extend the length. For information on using the 2- wire phone cord adaptor, see the documentation that came with it.

To extend your phone cord

1Using the phone cord supplied in the box with your HP all-in-one, connect one end to the coupler, then connect the other end to the port labeled "1-LINE" on the back of your HP all-in-one.

2Connect another phone cord to the open port on the coupler and to the telephone wall jack, as shown below.

Troubleshooting information

1 Telephone wall jack

2 Coupler

3 Phone cord supplied in the box with the HP all-in-one

I am having problems faxing over the Internet

Solution

Check the following:

●The FoIP service might not work properly when the HP all-in-one is sending and receiving faxes at high speed (33600bps). If you experience problems sending and receiving faxes, use a slower fax speed. You can do this by changing the Fax Speed setting from High (the default) to Medium. For information on changing this setting, see Set the fax speed.

●You can only send and receive faxes by connecting a phone cord to the port labeled "1-LINE" on the HP all-in-one and not from the Ethernet port. This means that your connection to the Internet must be done either through a

140 HP Officejet 6200 series all-in-one