connect it to a network using an HP JetDirect. For more information, see Uninstall and reinstall the software.

Use the Setup Guide for your HP all-in-one and follow the hardware setup instructions if you are performing an initial installation of both your HP all-in- one and HP JetDirect 175x.

2Follow the HP JetDirect 175x setup instructions to connect the print server to a LAN.

3Connect the HP JetDirect to the USB port on the rear of your HP all-in-one.

4Insert the installation CD that was supplied with the HP JetDirect into your computer's CD-ROM drive.

You will use this CD to locate the HP JetDirect on the network.

5Select Install to run the HP JetDirect installer.

6When prompted, insert the HP all-in-one installation CD.

Note If you are performing an initial installation of your HP all-in-one and

HP JetDirect 175x, do not run the HP all-in-one setup wizard. Just install the drivers following the instructions below.

If you decide at some later date to connect your HP all-in-one using a USB cable, then insert the HP all-in-one installation CD and run the setup wizard.

7Follow the steps appropriate for your operating system:

If you are using Windows XP or 2000:

a Browse to the root directory of the CD and select the correct driver .inf for your HP all-in-one.

The printer driver file, located in the root directory, is hpoprn08.inf.

If you are using Windows 98 or ME:

a Browse the CD for the "Drivers" folder and find the correct language subfolder. For example, for English speaking customers, navigate to the \enu\drivers \win9x_me directory, where enu is the English language directory and win9x_me is for Windows ME. The printer driver file is hpoupdrx.inf.

b Repeat for each of the drivers required.

8Complete the installation.

Note If, at some later time, you want to connect to your PC using a USB cable, disconnect the HP JetDirect from your HP all-in-one, uninstall the HP printer driver from your computer, and follow the instructions provided in the Setup Guide that came with your HP all-in-one.

To network connect your HP all-in-one using the HP JetDirect 175x (Macintosh)

1Follow the HP JetDirect 175x setup instructions to connect the print server to a LAN.

2Connect the HP JetDirect to the USB port on the rear of your HP all-in-one.

3Do one of the following:

If you are performing an initial installation of your HP all-in-one, make sure you insert the HP all-in-one installation CD into the CD-ROM drive on your computer and run the HP all-in-one setup wizard.

The network support software for your computer is installed at this time.

Connection information

User Guide

19

Page 22
Image 22
HP 6200 manual If you are using Windows XP or