Lenovo TD100X manual No-beep symptoms, Power-On Status to Enable

No-beep symptoms

The following table describes situations in which no beep code sounds when POST is completed.

vFollow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

vSee Chapter 3, “Parts listing, TD100 Types 6398, 6399, 6419, 6429, 4203, and 4206,” on page 25 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU).

vIf an action step is preceded by “(Trained service technician only),” that step must be performed only by a trained service technician.

No-beep symptom	Description	Action
No beeps occur, and the		1.	(Trained service technician only) Reseat the
server operates correctly.
			front information panel LED cable.
		2.	(Trained service technician only) Replace
			the front information panel LED assembly.
No beeps occur, and		See “Solving undetermined problems” on page
there is no video.		215.
No beeps occur after	The power-on status is Disabled.	1.	Run the Configuration/Setup Utility program
successful completion of
			and select Start Options; then, set
POST.
			Power-On Status to Enable.
		2.	(Trained service technician only) Reseat the
			operator information LED assembly.
		3.	(Trained service technician only) Replace
			the operator information LED assembly.

152ThinkServer TD100 and TD100x: Hardware Maintenance Manual