Lenovo TD100X manual Error code, Description, Action

vFollow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

vSee Chapter 3, “Parts listing, TD100 Types 6398, 6399, 6419, 6429, 4203, and 4206,” on page 25 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU).

vIf an action step is preceded by “(Trained service technician only),” that step must be performed only by a trained service technician.

Error code	Description	Action
166-400-100	DMC Self Test Result failed tests: xxx where	1.	Disconnect all server and option power cords
	xxx=flash, ROM, or RAM.		from the server, wait 30 seconds, reconnect the
			power cords, and retry.
		2.	Update the BIOS code, BMC, service processor,
			and diagnostics firmware (see “Updating the
			firmware” on page 15).
180-197-000	SCSI ASPI driver not installed.	1.	Remove the RAID adapter, if one is installed, and
			run the test again.
		2.	Reseat the SAS/SATA hard disk drive backplane
			cables.
		3.	Replace the following components one at a time,
			in the order shown, restarting the server each
			time:
			a. SAS/SATA hard disk drive backplane
			b. (Trained service technician only) System
			board
180-361-003	Failed fan LED test.	1.	Reseat the fan.
		2.	Replace the following components one at a time,
			in the order shown, restarting the server each
			time:
			a. Fan
			b. (Trained service technician only) System
			board
180-xxx-000	Diagnostics LED failure.	Run the diagnostic LED test for the failing LED.
180-xxx-001	Failed front LED panel test.	1.	Reseat the control-panel assembly cable.
		2.	Replace the following components one at a time,
			in the order shown, restarting the server each
			time:
			a. Control-panel assembly cable
			b. (Trained service technician only) System
			board
180-xx-002	Failed diagnostics LED panel test.	1.	Reseat the control-panel assembly cable.
		2.	Replace the following components one at a time,
			in the order shown, restarting the server each
			time:
			a. Control-panel assembly cable
			b. (Trained service technician only) System
			board

198ThinkServer TD100 and TD100x: Hardware Maintenance Manual