Lenovo TD100X manual Error code, Description, Action

vFollow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

vSee Chapter 3, “Parts listing, TD100 Types 6398, 6399, 6419, 6429, 4203, and 4206,” on page 25 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU).

vIf an action step is preceded by “(Trained service technician only),” that step must be performed only by a trained service technician.

Error code	Description	Action
166-198-000	BIOS cannot detect ASM. Reseat ASM	1.	Run the diagnostic test again.
	adapter in correct slot; ASM restart failure.
		2.	Correct other error conditions (including other
	Unplug and cold boot server to reset ASM.
			failed systems-management tests and items that
			are logged in the Remote Supervisor Adapter II
			SlimLine system-error log) and retry.
		3.	Disconnect all server and option power cords
			from the server, wait 30 seconds, reconnect the
			power cords, and retry.
		4.	Reseat the Remote Supervisor Adapter II
			SlimLine.
		5.	Replace the components listed in step 4 one at a
			time, in the order shown, restarting the server
			each time.
166-201-000	ISMP indicates I2C errors on bus X.	(Trained service technician only) Replace the system
		board.
166-201-001	ISMP indicates I2C errors on bus P.	1.	(Trained service technician only) Reseat the
			power backplane.
		2.	Replace the following components one at a time,
			in the order shown, restarting the server each
			time:
			a. (Trained service technician only) Power
			backplane
			b. (Trained service technician only) System
			board
166-201-002	ISMP indicates I2C errors on bus I.	(Trained service technician only) Replace the system
		board.
166-201-003	ISMP indicates I2C errors on bus C.	(Trained service technician only) Replace the system
		board.
166-201-004	ISMP indicates I2C errors on bus M.	1.	Reseat the DIMM.
		2.	Replace the following components one at a time,
			in the order shown, restarting the server each
			time:
			a. DIMM
			b. (Trained service technician only) System
			board
166-201-005	ISMP indicates I2C errors on bus S.	1.	Reseat the SAS/SATA hard disk drive backplane
			cables.
		2.	Replace the following components one at a time,
			in the order shown, restarting the server each
			time:
			a. SAS/SATA hard disk drive backplane
			b. System board

196ThinkServer TD100 and TD100x: Hardware Maintenance Manual