Installing a hot-swap power supply
This procedure applies only to server models that have
To install a
1.Remove the power supply filler.
2.Place the power supply into the bay guides.
1 | Power supply filler |
2 | Release latch |
3 | Power supply |
3.Using the handle, push the power supply toward the front of the chassis until it locks into place.
4.Connect one end of the power cord into the connector on the back of the power supply and connect the other end of the power cord into a properly grounded electrical outlet.
5.Make sure that both the ac and dc power LEDs on the rear of the power supply are lit, indicating that the power supply is operating correctly.
