Lenovo TD100X manual ThinkServer TD100 and TD100x Hardware Maintenance Manual

vFollow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

vSee Chapter 3, “Parts listing, TD100 Types 6398, 6399, 6419, 6429, 4203, and 4206,” on page 25 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU).

vIf an action step is preceded by “(Trained service technician only),” that step must be performed only by a trained service technician.

System-error log message	Action
System over recommended voltage for +12v	1.	Reseat the following components:
		a. Hot-swap power supplies (if any are installed)
		b. (Trained service technician only) Power-supply cables on
		the system board
	2.	(Trained service technician only) Replace the system board.
System over recommended voltage on +2.5v	1.	Reseat the following components:
		a. Hot-swap power supplies (if any are installed)
		b. (Trained service technician only) Power-supply cables on
		the system board
	2.	(Trained service technician only) Replace the system board.
System over recommended voltage on	1.	Reseat the following components:
continuous +5v
		a. Hot-swap power supplies (if any are installed)
		b. (Trained service technician only) Power-supply cables on
		the system board
	2.	(Trained service technician only) Replace the system board.
System shut off due to system board under	1.	Make sure that the fans have good airflow and are not
temperature
		obstructed.
	2.	(Trained service technician only) Replace the system board.
System shutoff due to +12v over voltage	1.	Reseat the following components:
		a. Hot-swap power supplies (if any are installed)
		b. (Trained service technician only) Power-supply cables on
		the system board
	2.	(Trained service technician only) Replace the system board.
System shutoff due to +12v under voltage	1.	Reseat the following components:
		a. Hot-swap power supplies (if any are installed)
		b. (Trained service technician only) Power-supply cables on
		the system board
	2.	(Trained service technician only) Replace the system board.
System shutoff due to +2.5v over voltage	1.	Reseat the following components:
		a. Hot-swap power supplies (if any are installed)
		b. (Trained service technician only) Power-supply cables on
		the system board
	2.	(Trained service technician only) Replace the system board.
System shutoff due to +2.5v under voltage	1.	Reseat the following components:
		a. Hot-swap power supplies (if any are installed)
		b. (Trained service technician only) Power-supply cables on
		the system board
	2.	(Trained service technician only) Replace the system board.

210ThinkServer TD100 and TD100x: Hardware Maintenance Manual