Lenovo TD100X manual Installing a microprocessor and heat sink

Installing a microprocessor and heat sink

Important: Some models support dual-core processors and quad-core processors. Do not mix dual-core and quad-core processors in the same server. Install all dual-core processors or all quad-core processors in the server.

To install the microprocessor and heat sink, complete the following steps.

1	Heatsink 2	3	Microprocessor 2 VRM
2	Microprocessor 2	4	Microprocessor release lever

1.Touch the static-protective package that contains the microprocessor to any unpainted metal surface on the server. Then, remove the microprocessor from the package.

2.Remove the protective cover, tape, or label from the surface of the microprocessor socket, if any is present.

3.Rotate the release lever on the microprocessor socket to the fully open position.

Attention: Make sure that the release lever on the microprocessor socket is in the fully open position before you insert the microprocessor in the socket. Failure to do so might result in permanent damage to the microprocessor, microprocessor socket, and system board.

Microprocessor release lever (fully open)

Microprocessor bracket frame

Chapter 4. Removing and replacing server components 139