Lenovo TD100X manual Diagnostics

vFollow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

vSee Chapter 3, “Parts listing, TD100 Types 6398, 6399, 6419, 6429, 4203, and 4206,” on page 25 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU).

vIf an action step is preceded by “(Trained service technician only),” that step must be performed only by a trained service technician.

Error code	Description	Action
180-xxx-005	Failed SCSI backplane LED test.	1.	Reseat the following components:
			a. SAS/SATA hard disk drive
			b. SAS/SATA hard disk drive backplane cable
			c.	RAID adapter
		2.	Replace the following components one at a time,
			in the order shown, restarting the server each
			time:
			a. SAS/SATA hard disk drive backplane
			b. SAS/SATA hard disk drive backplane cable
			c.	RAID adapter
			d. (Trained service technician only) System
				board
180-xxx-006	Failed memory LED test.	1.	Reseat the DIMM.
		2.	Replace the following components one at a time,
			in the order shown, restarting the server each
			time:
			a. DIMM
			b. (Trained service technician only) System
				board
180-xxx-007	Failed power supply fan LED test.	1.	Reseat the power supply.
		2.	Replace the following components one at a time,
			in the order shown, restarting the server each
			time:
			a.	Power supply
			b. (Trained service technician only) System
				board
180-xxx-008	Failed I/O board LED test.	(Trained service technician only) Replace the system
		board.
180-xxx-009	Failed Active™ PCI LED test.	(Trained service technician only) Replace the system
		board.
201-198-000	Memory Test Aborted: Could not run the	1.	Restart the server.
	test; suspect system board error.
		2.	Run the diagnostic test again.
		3.	Reinstall the diagnostic programs (see “Updating
			the firmware” on page 15).
		4.	(Trained service technician only) Replace the
			system board.
201-198-00n	Memory Test Aborted: Could not run the	1.	Restart the server.
	test.
		2.	Run the diagnostic test again.
	Note: n = 1-9 (programming error).
		3.	Reinstall the diagnostic programs (see “Updating
			the firmware” on page 15).

Chapter 5. Diagnostics 199