vNon-hot-swap models, lift up the power-supply cage handle and pull the power-supply cage assembly all the way up until the retainer latch locks the cage in place on the chassis.
5.Remove the front fan-cage assembly (see “Removing the front system fan cage assembly” on page 108.
6.Remove the simple-swap hard disk drives that are installed in the hard disk drive cage (see “Removing a simple-swap hard disk drive” on page 92).
7.Disconnect the combination signal/power cable from the simple-swap backplate.
8.Lift up on the spring-release latch on the side of the drive cage and rotate the simple-swap backplate away from the drive cage until the backplate tabs at the bottom of the drive cage disengage from the chassis.
1 | Locator pins |
2 | Spring-release latches |
3 | Hard disk drive backplate |
9.Remove the simple-swap backplate and set it aside.
10.If you are instructed to return the simple-swap backplate, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.
Chapter 4. Removing and replacing server components 129
