Note: Make sure the photo print settings you select match your current printer settings. For information on changing printer photo settings, see “Using Photo and the Photo Card Mode menu” on page 45.

1Load a stack of photo paper in Tray 1 or one sheet in the small media feeder.

Note: Make sure to load the paper with the glossy or printable side facing down. (If you are not sure which side is the printable side, see the instructions that came with the paper.

2Insert a memory card with a DPOF selection.

The message Memory Card Detected appears briefly on the display.

3From the main menu, make sure Photo is highlighted, and then press .

The Photo Card Mode menu appears with View Slideshow highlighted.

4Press or repeatedly until Print Camera Selections is highlighted.

5Press .

6Press to display the DPOF selection you specified. A preview of the print job appears.

7Press .

Using a PictBridge-enabled digital camera to control printing photos

You can connect a PictBridge-enabled digital camera to the printer, and use the buttons on the camera to select and print photos.

1Insert one end of the USB cable into the camera.

Note: Use only the USB cable that came with the digital camera.

2Insert the other end of the cable into the PictBridge port on the front of the printer.

SD/M

 

MS

MC

XD

C

 

 

 

F/MD

 

 

 

PictBr

 

 

idge

Warning: Do not touch the USB cable, any network adapter, or the printer in the area shown while actively printing from a PictBridge-enabled digital camera. A loss of data can occur. Also, do not remove the USB cable or network adapter while actively printing from a PictBridge-enabled digital camera.

104

Page 104
Image 104
Lexmark 9300 Series manual 104