Agilent Technologies E8285A manual Ch Offset, Chan Space User Defined

Chapter 4, Description of Fields

Fields

Example

OUTPUT 714;"CALLP:NTACS:CEXT:ACT?"

OUTPUT 714;"CALLP:NTACS:CEXT:SETT ‘NARROW’"

OUTPUT 714;"CALLP:NTACS:CEXT:SETT?"

ENTER 714;Last_ord_sent$

Screens Where Field is Present

CALL CONTROL

Ch Offset

Use the channel offset field to enter the frequency difference between the Tune Freq setting and the center of the adjacent channels you want to measure. This is an absolute value; only positive values can be entered. See figure 54 .

Screens Where Field is Present

ADJACENT CHANNEL POWER

Chan Space (User Defined)

This field specifies the RF channel spacing when the RF Display field is set to Chan, and the RF Chan Std field is set to USER-DEF.

For example, entering 25 kHz causes a 25 kHz spacing between each channel. If the receive frequency for channel 1 is 150.500 MHz, channel 2’s receive frequency would be 150.525 MHz.

Operating Considerations

The value of this field is only used if the RF Display field is set to Chan, and the RF Chan Std field is set to USER-DEF.

See Also

(Gen)-(Anl)field description, on page 269 RF Chan Std field description, on page 365

Base Freq (User Defined) field description, on page 183

Screens Where Field is Present

CONFIGURE

202

S:\agilent\e8285\REFGUIDE\MANUAL\fields.chp