Agilent Technologies E8285A manual Test Procedure Run Mode, Test Status

Chapter 4, Description of Fields

Fields

Test Procedure Run Mode

This field selects how the test will be run. The underlined entry is the active choice.

•Continuous runs the tests in the test sequence one after another without stopping. Testing pauses only if the operator is required to interact with the UUT or Test Set. In- teractions such as changing UUT channels and setting squelch and audio levels cause testing to pause. Selecting Stop in the If Unit-Under-Test Fails: field may also stop a test.

•Single Step runs the tests in the test sequence one at a time. The operator is prompt- ed to press Continue to proceed with testing.

Screens Where Field is Present

TESTS (Execution Conditions)

Test Status

The labels under Test Status are highlighted by annunciators. When lit, these annunciators indicate that an event took place or that a condition exists. All status annunciators can be queried over GPIB.

See "Connected (annunciator)" on page 423.

See "Svc Opt 2/9 (annunciator)" on page 424.

See "Testing (annunciator)" on page 424.

See "Passed (annunciator)" on page 424.

See "Failed (annunciator)" on page 425.

See "Max Frames (annunciator)" on page 425.

Connected (annunciator)

This annunciator indicates that the Test Set and a mobile station have completed the signaling steps required to establish a CDMA call, and the Test Set has not had any indication that the call has ended or should end.

•For a call to the mobile station (initiated by the Test Set), the mobile station must ring and then be answered before this annunciator will light. When using Service Option 2, the mobile station will automatically answer a call and go to the Connected state.

•For a call to the Test Set (initiated by the mobile station), the Test Set will automatically answer the call (if the Answer Mode field is set to Auto), and the Connected annunciator will light. If the Answer Mode field is set to Manual, a message will appear prompting you to press the ANS key.

When a call is terminated, this annunciator will go out.

423