Agilent Technologies E8285A manual Register Analog, Register Cdma, Causes the mobile to register

Chapter 4, Description of Fields

Fields

Register (Analog)

This field is used to initiate a registration of the mobile station that is connected to the Test Set. The Test Set must be in the active state (that is, the Active annunciator must be lit) before you can attempt to register the mobile station.

The :REGister command is used to control this field.

There is no query form of the :REGister command.

Syntax

:REGister

Example

OUTPUT 714;"CALLP:REG"

Screens Where Field is Present

CALL CONTROL

Register (CDMA)

Selecting this field causes the mobile station to perform a zone-based registration.

The Test Set first transmits an alternate SID/NID pair that causes the mobile station to respond by registering, as if the mobile station were moving into a new zone. This SID/NID pair, used in the System Parameters Overhead Message, settable (see Rgstr NID field description, on page 371 and Rgstr SID field description, on page 372).

After the mobile station has registered the first time, the Test Set sends another SID/NID pair, this time using the values set in Network ID and System ID fields (see the "CDMA Cell Site Configuration Screen" on page 101). These are the main SID and NID, and the mobile station will register again and set its roam status according to these values.

GPIB Example

“DISP CCNT;CDMA:MOBile:REGister“

causes the mobile to register.

358

S:\agilent\e8285\REFGUIDE\MANUAL\fields.chp