Cisco Systems Cisco 12008 manual Configuring Global Parameters

Configuring the Cisco 12008

Configuring Global Parameters

When you first enter the setup facility or issue the setup command, you are queried by the system to configure global parameters for your router.

To boot the system and establish global configuration parameters, perform the following steps:

Step 1 Connect a console terminal to the console port on the RP.

Step 2 Boot the system to display the user EXEC prompt (Router>).

After about 30 seconds, the following display appears on the console, indicating that you have successfully booted the system:

System Bootstrap, Version 11.2(8)GS [biff 571], RELEASED SOFTWARE

Copyright (c) 1994-1997 by Cisco Systems, Inc.

Restricted Rights Legend

Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph

(c)of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph

(c)(1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013.

Cisco Systems, Inc.

170 West Tasman Drive

San Jose, California 95134-1706

Cisco Internetwork Operating System Software

IOS (tm) GS Software (GSR-P-MZ), Released Version 11.2(8)GS [biff- bfr_112]

Copyright (c) 1986-1997 by Cisco Systems, Inc.

Compiled Mon 25-Aug-97 20:13 by biff

Image text-base: 0x60010900, data-base: 0x604FE000

Cisco 12008/GRP (R5000) processor (revision 0x00) with 65536K bytes of memory.

Processor board ID 00000000

R5000 processor, Implementation 35, Revision 2.1 (512KB Level 2

Cache)

Last reset from power-on

1 clock scheduler card(s)

3 switch fabric card(s)

4-14Cisco 12008 Gigabit Switch Router Installation and Configuration Guide