Cisco Systems Cisco 12008 manual Diagnostic Testing Sequence, Where

	Diagnostic Testing Sequence
where:
slot	Specifies which card cage slot to test. The diagnostic software
	determines the type of card in the slot and downloads the
	appropriate tests.
halt	(Optional) Stops the active diagnostic test.
previous	(Optional) Allows you to examine the last test results on the card,
	stored in EEPROM, specified by the slot parameter.
mbus1	(Optional) Forces the route processor to load diags from the
	mbus.
verbose	(Optional) Turns on the status messaging capability of the
	diagnostics. The default is minimum messaging.
wait	(Optional) Stops the diagnostics from reloading the Cisco IOS
	image following the completion of diagnostic testing. The card
	must be ejected from the slot, reinstalled in the slot, and
	reconfigured manually.
coe2	(Optional) Continues testing even after a failed test.
(Continue on error)

1.Using this option results in a 15-minute delay before test results are returned. This command option is available when using Cisco IOS Release 12.0(21)S or 12.0(21)ST, or a later release of 12.0S or 12.0ST.

2.Not recommended for use on operational, business-critical routers. This command option is available when using Cisco IOS Release 12.0(21)S or 12.0(21)ST, or a later release of 12.0S or 12.0ST.

To stop diagnostic testing at any time, enter the halt option in the command, at the privileged EXEC mode prompt on the system console:

diag slot halt

Diagnostic Testing Sequence

When testing a card, the diagnostics perform the following operations in this sequence:

1Halts the normal operation of the card.

The card is no longer available for network traffic.

Running Diagnostics on the Cisco 12008 6-3