Configuring the Cisco 12008
Cisco 12008 Gigabit Switch Router Installation and Configuration Guide
4-18
In either case, you cannot use a number as the first character. Spaces, however,
are valid password characters. For example, “two words” is a valid password.
Leading spaces are ignored, but trailing spaces are recognized.
Step7 Enter the virtual terminal password when prompted to do so:
Enter virtual terminal password: bambam
For future use, make a note of this password.
Step8 In most cases, you will use IP routing as the network layer protocol. If you
specify IP, you must also specify an interior routing protocol.
Enter yes (the default) or press Return to configure IP; do likewise to select the
Interior Gateway Routing Protocol (IGRP) as the interior routing protocol.
Specify the IGRP autonomous system number, as follows:
Configure IP? [yes]: yes
Configure IGRP routing? [yes]: yes
Your IGRP autonomous system number [1]: 199
Note For complete information about IP routing and autonomous system
numbers, refer to the appropriate software configuration publications listed in
the section entitled “If You Need More Configuration Information.” The
Ethernet interface does not support external routing functions.
Step9 Enter yes or no to the following query to accept or refuse Simple Network
Management Protocol (SNMP) management:
Configure SNMP Network Management? [yes]:
Community string [public]: