Cisco Systems Cisco 12008 manual Using Flash Memory Cards in the RP, Router# show start-up config

Performing Other Configuration Tasks

Step 11 Enter the show start-up config command at the privileged EXEC mode prompt to display the enable password in the configuration file:

Router# show start-up config

.

.

.

Step 12 Issue the configure terminal command at the privileged EXEC mode prompt to enter the global configuration mode:

Router# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#

Step 13 Change the software configuration register setting back to its original value (as noted earlier from Step 3). Alternatively, change this value to 0x0102 (the factory default) by issuing the config-register 0xvalue command:

Router(config)# config-register0xvalue

Router(config)#

Step 14 Exit the global configuration mode by entering Ctrl-Z:

Router(config)# Ctrl-Z

Router#

Step 15 Reboot the router and enable it using the recovered password.

Using Flash Memory Cards in the RP

This section presents procedures for using Flash memory cards in the Route Processor (RP). The following topics are covered in this section:

•

•

•

•

•

Installing and Removing a Flash Memory Card in a RP

Formatting a Flash Memory Card

Specifying a Cisco IOS Image for Booting the System

Console Commands Associated with Flash Memory Use

Enabling Booting from Flash Memory

4-46Cisco 12008 Gigabit Switch Router Installation and Configuration Guide