Adding, Removing, or Replacing an AC-Input Power Supply

Caution To prevent damage to the blind-mating connector at the rear of the power supply, do not use excessive speed or force when inserting the power supply into the bay.

Note All necessary electrical connections between the power supply and the backplane are accomplished automatically by means of the blind-mating connector at the rear of the power supply.

Step 7 Using a 1/4-inch flat-blade screwdriver, tighten the captive installation screw on the faceplate of the power supply (see Figure 7-3).

Step 8 Connect the source AC power cord to the AC receptacle on the power supply faceplate (see Figure 7-4a). Secure the bail latch over the source AC power cord (see Figure 7-4b).

Step 9 Connect the other end of the source AC power cord to its power source (see Figure 7-4c).

Step 10 Set the rotary power switch on the new AC-input power supply to the ON (1) position.

To verify that the new AC-input power supply is operating properly, proceed to the section entitled “Verifying the Installation of an AC-Input Power Supply.”

7-10Cisco 12008 Gigabit Switch Router Installation and Configuration Guide

Page 290
Image 290
Cisco Systems Cisco 12008 manual Adding, Removing, or Replacing an AC-Input Power Supply