Cisco Systems Cisco 12008 manual Verifying the Installation of an AC-Input Power Supply

Adding, Removing, or Replacing an AC-Input Power Supply

Note All the necessary electrical connections between the power supply and the backplane are accomplished automatically by means of the blind-mating connectors.

Step 14 Using a 1/4-inch flat-blade screwdriver, tighten the captive installation screw on the power supply faceplate.

Step 15 Connect the source AC power cord to the AC receptacle on the power supply faceplate.

Step 16 Secure the bail latch over the source AC power cord to secure it in the AC receptacle.

Step 17 Set the rotary power switch on the new AC-input power supply to the ON () position.

To verify that the new power supply is operating properly, perform the procedure in the following section.

Verifying the Installation of an AC-Input Power Supply

To verify the operation of a newly-installed AC-input power supply, first apply power to the unit and then observe the status of the LEDs on the power supply faceplate.

To verify the operation of a newly-installed AC-input power supply, perform the following steps:

Step 1 First, verify that the following conditions have been satisfied:

•The power supply is completely inserted into the bay and secured in place with its captive installation screw.

•A vacant power supply bay is covered with a blank filler panel to ensure EMI compliance and the proper flow of cooling air through the router enclosure.

•The source AC power cable is properly connected to the AC receptacle on the power supply faceplate.

Maintaining the Cisco 12008 7-15