Cisco Systems Cisco 12008 manual YES Nvram

Configuring the Cisco 12008

Pressing Return in either case accepts the default response [yes].

The following sample display results from a yes response to the current interface summary query that is entered while you are using the setup facility. The display shows that no interfaces have been configured:

Interface	IP-Address	OK? Method	Status	Protocol
Ethernet0	unassigned	YES unset	administratively down down
POS3/0	unassigned	YES unset	administratively down down
POS3/1	unassigned	YES unset	administratively down down
POS3/2	unassigned	YES unset	administratively down down
POS3/3	unassigned	YES unset	administratively down down
ATM4/0	unassigned	YES unset	administratively down down
.
.
.
		The following sample display results from a yes response to the current interface
		summary query that is entered while you are using the setup command. The
		display shows that some interfaces have already been configured.
Interface	IP-Address	OK? Method	Status	Protocol
Ethernet0	3.3.1.1	YES NVRAM	up	up
POS3/0	2.1.1.1	YES NVRAM	up	up
POS3/1	2.1.1.2	YES NVRAM	up	up
POS3/2	2.1.1.3	YES NVRAM	up	up
POS3/3	2.1.1.4	YES NVRAM	up	up
ATM4/0	1.1.1.2	YES NVRAM	up	up

.

.

.

Step 4 Select the protocols that you intend to support for your network interfaces.

For IP–only installations, you can accept the default values for most of the questions.

4-16Cisco 12008 Gigabit Switch Router Installation and Configuration Guide