Enterasys Networks XSR CLI Configuring Hardware Controllers

XSR CLI Reference Guide 4-83
4
Configuring Hardware Controllers
Observing Syntax and Conventions
TheCLIcommandsyntaxandconventionsusethenotationdescribedinthefollowingtable.
Hardware Controller Commands
ThefollowingcommandsetsallowyoutodefinesynchronizationfeaturesfortheXSR:
•“HardwareControllerCommands”onpage 4‐83
•“HardwareControllerClearandShowCommands”onpage 4‐92
clock rate
Thiscommandconfigurestheclockrateforthehardwareconnectionsonaserialinterface.The
commandisvalidandtakeseffectonlywhentheinterfaceisrunninginAsynchronousmode.For
Synchronousmode,theclockrateisreceivedexternally.
Convention Description
xyz Key word or mandatory parameters (bold)
[x][ ] Square brackets indicate an optional parameter (italic)
[x | y | z][ | ] Square brackets with vertical bar indicate a choice of values
{x | y | z}{ | } Braces with vertical bar indicate a choice of a required value
[x {y | z} ] [{ | } ] Combination of square brackets with braces and vertical bars indicates
a required choice of an optional parameter
(config-if<xx>)xx signifies interface type and number, e.g.: F1, S2/1.0, D1, M57, G3. F
indicates a FastEthernet, and G a GigabitEthernet interface.
Next Mode entries display the CLI prompt after a command is entered.
soho.enterasys.com Italicized, non-syntactic text indicates either a user-specified entry or text with
special emphasis
Note: The clock rate cannot be changed in loopback mode.