Enterasys Networks XSR CLI ip pim query-interval, ip pim rp-address

PIM Commands
7-92 Configuring IP Multicast
Default
60seconds
Example
ThefollowingexamplechangesthePIM‐SMmessageintervalto120seconds:
XSR(config-if<F1>)#ip pim message-interval 120
ip pim query-interval
ThiscommandsetsthefrequencyofProtocolIndependentMulticast(PIM)routerquery
messages.
Syntax
ip pim query-interval seconds
Syntax of the “no” Form
Thenoformofthiscommandsetstheintervaltothedefaultvalue:
no ip pim query-interval
Mode
Interfaceconfiguration:XSR(config-if<xx>)#
Default
30seconds
Example
ThisexampleresetsthePIMrouterquerymessageintervalto60seconds:
XSR(config-if<F1>)#ip pim query-interval 60
ip pim rp-address
ThiscommandsetsthestaticRendezvousPoint(RP)forthespecificmulticastgroup.
(DynamicallylearnedRPalwayshasahigherprioritythanstaticallyconfiguredRP.)
Syntax
ip pim rp-address rp-address [access-list]
seconds IntervaltosendperiodicPIMrouterquerymessages.Range:1to65535.
rp-address IPaddressofaroutertobeaPIMRP.ThisisaunicastIPaddressin
four‐part,dottednotation.
access-listACLnumberdefinesforwhichmulticastgroupstheRPshouldbeused.