Enterasys Networks XSR CLI ip rip max-retransmissions, ip rip polling-interval

Triggered on Demand RIP Commands
XSR CLI Reference Guide 5-143
•ip rip triggered-on-demand‐Enablesthefunctionalityonthespecifiedinterface.Referto
page192forthecommanddefinition.
ip rip max-retransmissions
Thiscommandsetsthemaximumnumberofretransmissionstobesent.
Syntax
ip rip max-retransmissions number
Syntax of the “no” Form
Thenocommandresetsthemaximumretransmissionsvaluetothedefault:
no ip rip max-retransmissions
Mode
Interfaceconfiguration:XSR(config-if<xx>)#
Default
36
Example
Thisexamplesetsthenumberofretransmissionsto50:
XSR(config)#interface serial 1/0
XSR(config-if<S1/0>)#ip address 1.0.0.0 255.0.0.0
XSR(config-if<S1/0>)#no shutdown
XSR(config-if<S1/0>)#ip rip triggered-on-demand
XSR(config-if<S1/0>)#ip rip max-retransmissions 50
XSR(config)#router rip
XSR(config-router)#network 1.0.0.0
ip rip polling-interval
ThiscommandsetsthepollingintervalfortriggeredRIPrequests.Ifarequestgetsnoresponse
afterretransmissionspeak,requestswillcontinuallytransmitatintervalssetbythiscommand.
Syntax
ip rip polling-interval interval
number Numberofretransmissions,rangingfrom2to120.
Note: The polling interval should be less than the dialer spoofing timeout.
interval Pollingperiodrangingfrom10to600seconds.