Enterasys Networks XSR CLI ppp bap callback, ppp bap number

Multilink PPP Commands
XSR CLI Reference Guide 8-111
XSR(config-if<D57>)#ppp bap call accept
ppp bap callback
ThiscommandsetsenablesBandwidthAllocationProtocol(BAP)callbackparametersonadialer
interfacetosetupBandwidth‐on‐Demand(BoD).Itpermitstheporttoinitiateaddingalinktoor
requestingalinkfromapeer.ItappliestoDialerinterfacesonly.
Themultilink load-thresholdcommandisasecondmeansbywhichtheXSRcontrolstraffic
viaBoD.Itisalsoprovidedbysettingthemultilink min-links command.
Syntax
ppp bap callback {accept | request}
Mode
DialerInterfaceconfiguration:XSR(config-if<Dx>)#
Mode of the “no” Form
Thenoformofthiscommandremovescallbackconfiguration:
no ppp bap callback {accept | request}
Example
ThefollowingexampleconfiguresBAPtoacceptandrequestcallbacks:
XSR(config)#interface dialer 1
XSR(config-if<D1>)#encapsulation ppp
XSR(config-if<D1>)#no shutdown
XSR(config-if<D1>)#ppp bap callback accept
XSR(config-if<D1>)#ppp bap callback request
ppp bap number
ThiscommandspecifiestheBandwidthAllocationProtocol(BAP)phonenumberwhichapeer
candialtoconnectandsetupBandwidth‐on‐Demand(BoD).Itappliestodialerinterfacesonly.
Themultilink load-thresholdcommandisasecondmeansbywhichtheXSRcontrolstraffic
viaBoD.Itisalsoprovidedbysettingthemultilink min-links command.
Note: You must configure multilink load-threshold to run BAP.
accept Localrouterinitiatesalinkadditionuponpeernotification.
request Localrouterrequestsapeertoinitiatealink.
Note: The multilink load-threshold command must be set to operate BAP.