Enterasys Networks XSR CLI frame-relay lmi-n392dte

Frame Relay Commands
9-90 Configuring Frame Relay
Default
3
Mode
Interfaceconfiguration:XSR(config-if<xx>)#
Example
ThisexamplesetstheLMIfailurethresholdto5fortheDCEdevice:
XSR(config)#interface serial 1/0
XSR(config-if<S1/0>)#encapsulation frame-relay
XSR(config-if<S1/0>)#frame-relay intf-type dce
XSR(config-if<S1/0>)#frame-relay lmi-n392dce 5
frame-relay lmi-n392dte
ThiscommandsetstheerrorthresholdonaDataTerminalEquipment(DTE)interface.
Syntax
frame-relay lmi-n392dte threshold
Syntax of the “no” Form
Usethenocommandtoremovethecurrentsetting:
no frame-relay lmi-n392dte
Default
3
Mode
Interfaceconfiguration:XSR(config-if<xx>)#
Example
ThefollowingexamplesetstheLMIfailurethresholdto5fortheDTEdevice:
XSR(config)#interface serial 1/0
XSR(config-if<S1/0>)#encapsulation frame-relay
XSR(config-if<S1/0>)#frame-relay intf-type dte
XSR(config-if<S1/0>)#frame-relay lmi-n392dte 5
threshold Errorthreshold,rangingfrom1to10.