Enterasys Networks XSR CLI oam retry, pvc

Other ADSL Commands
13-96 Configuring ADSL
Example
ThefollowingexamplesetstheOAMfrequencyto20seconds:
XSR(config-if<ATM0/1/0.1>)#oam-pvc manage 20
oam retry
ThiscommandconfiguresparametersrelatedtoOAMcellhandlingforATMVCmanagement.
ThiscommandrequiresaproperlyconfiguredATMsub‐interface.
Syntax
oam retry up-count down-count retry-frequency
Syntax of the “no” Form
Thenoformofthiscommandreturnsthisparametertoitsdefaultsetting:
no oam retry
Mode
ATMSub‐Interfaceconfiguration:XSR(config-if<ATMx/x/x.x>)#
Default
•Initialdown‐countvalue:5
•Initialup‐countvalue:3
•Initialretry‐frequencyvalue:10
•DefaultsettingsapplyonlywhenOAMmanagementhasbeenenabledwiththeoam-pvc
command.
Example
Thisexamplesetstheup‐countto5,thedown‐countto8,andtheretry‐frequencyto2seconds:
XSR(config-if<ATM0/1/0.1>)#oam retry 5 8 2
pvc
Thiscommandsetsthesub‐interfacecircuittypetoPVCandspecifiesATMVPI/VCIvalues.This
commandrequiresaproperlyconfiguredATMsub‐interface.
up-count Sumofconsecutiveend‐to‐endF5OAMloopbackcellsresponsesthatmust
bereceivedtochangetheVCconnectionstatetoup.Range:0to255.
down-count Sumofconsecutiveend‐to‐endF5OAMloopbackcellsresponsesthatarenot
receivedtochangetheVCconnectionstatetodown.Range:0to255.
retry-
frequency
Intervalbetweensendingend‐to‐endF5OAMloopbackcellswhenachange
intheup/downstateofaVCisbeingverified.Range:1to3600seconds.