Enterasys Networks XSR CLI Configuring the Point-to-Point Protocol

XSR CLI Reference Guide 8-83
8
Configuring the Point-to-Point Protocol
Observing Syntax and Conventions
TheCLISyntaxandconventionsusethenotationdescribedinthefollowingtable.
PPP Commands
ThischapterdefinesPoint‐to‐PointProtocol(PPP)serviceprofiles,specifyandmonitorserial
ports,anddefineMultilinkPPPandBandwidthAllocationProtocol(BAP)functionalityinthe
followingcommandsets:
•“PPPDebug,ClearandShowCommands”onpage 8‐97.
•“MultilinkPPPCommands”onpage 8‐108.
•“MultilinkShowCommands”onpage 8‐122.
Convention Description
xyz Key word or mandatory parameters (bold)
[x] [ ] Square brackets indicate an optional parameter (italic)
[x | y | z] [ | ] Square brackets with vertical bar indicate a choice of values
{x | y | z} { | } Braces with vertical bar indicate a choice of a required value
[x {y | z} ] [{ | } ] Combination of square brackets with braces and vertical bars indicates a
required choice of an optional parameter
(config-if<xx>)xx signifies interface type and number, e.g.: F1, S2/1.0, D1, M57, G3. F
indicates a FastEthernet, and G a GigabitEthernet interface.
Next Mode entries display the CLI prompt after a command is entered.
Sub-command headings are displayed in red text.
soho.enterasys.com Italicized, non-syntactic text indicates either a user-specified entry or text with
special emphasis