Enterasys Networks XSR CLI dialer idle-timeout

DOD/BOD Commands
XSR CLI Reference Guide 10-99
Syntax of the “no” Form
Thenoformofthiscommanddisablesthefeature:
no dialer caller number
Mode
DialerInterfaceconfiguration:XSR(config-if<Dx>)#
Example
Thefollowingexampleconfiguresthedialercallernumberstoscreen:
XSR(config)#interface dialer 1
XSR(config-if<D1>)#dialer caller 5084712345
dialer idle-timeout
ThiscommandspecifiestheidletimeoutintervalbeforetheXSRdisconnectstheline.Thetimeout
triggerisbasedonoutboundtrafficonly.
Syntax
dialer idle-timeout seconds
Syntax of the “no” Form
Usethenoformofthiscommandtoresettheidletimeouttothedefault:
no dialer idle-timeout
Mode
DialerInterfaceconfiguration:XSR(config-if<Dx>)#
Default
120seconds
Examples
Thefollowingexampleresetstheidle‐timeout:
Note: If the ISDN switch does not provide the calling number, callback will fail.
Caution: This command must be invoked on the called side of a link with a 0 value to ensure the
link is not dropped after 120 seconds by the called side.
seconds Interval before disconnecting the line, ranging from 0 to 2,147,483 seconds.
Specifying 0 disables the timeout.