Enterasys Networks XSR CLI dialer string, dialer wait-for-carrier-time (interface configuration)

Dialer Interface Commands
10-86 Configuring the Dialer Interface
dialer string
Thiscommandcreatesastringusedtoplaceacalladestinationorsubnet.Typically,itisthe
telephonenumberneededfordialing.
Syntax
dialer string dial-string [class class-name]
Syntax of the “no” Form
no dialer string dial-string
Mode
Interfaceconfiguration:XSR(config-if<xx>)#
Example
Thisexampleshowsthatdialerinterface0configuredtousemap‐classXXXwhenusingdialer
string9055559988:
XSR(config-if)#interface dialer 0
XSR(config-if<D0>)#dialer string 9055559988 class XXX
dialer wait-for-carrier-time (interface configuration)
Thiscommandconfiguresthetimeadialerinterfacewaitsforacarriersignal.Itisusedwhen
configuringaparticulardialerinterface.
Syntax
dialer wait-for-carrier-time seconds
Syntax of the “no” Form
Thenoformofthiscommandresetstodefaultvalue:
no dialer wait-for-carrier-time
Default
60seconds
Mode
Interfaceconfiguration:XSR(config-if<xx>)#
dial-string Phone number to be sent to a dial device.
class-name Map class associated with this dialer string.
seconds Interval the interface waits for a carrier signal when a call is placed via the dial device.