Enterasys Networks XSR CLI dialer pool

Dialer Interface Commands
10-84 Configuring the Dialer Interface
•Thedialer stringcommandmustbesettothedialerinterfacethatownsthedialerpool
wherethedialerDTRserialinterfaceisadded.
•Theserialinterfacemustbeconfiguredforsynchronousdatamode.
•ThemodemmustbeconfiguredwithDTR‐controlleddialinginterface,CTSfollowsDCD,
DTRdisconnects,syncdatamodeandapresetdialingouttelephonenumber.
Syntax
dialer dtr
Syntax of the “no” Form
no dialer dtr
Default
DTRdialingisdisabled
Mode
Interfaceconfiguration:XSR(config-if<xx>)#
Example
XSR(config-if<S1/1>)#dialer dtr
dialer pool
Thiscommandspecifieswhichdialerpoolthedialerinterfaceshoulduse.Thedialerinterfacewill
useoneofthephysicalinterfacesinthedialerpooltoattachtotheinterfaceʹsconfigured
destination.
Syntax
dialer pool number
Syntax of the ��no” Form
no dialer pool
Default
Disabled‐nopoolisspecified.
number Dial pool number, ranging from 1 to 255.