Enterasys Networks XSR CLI ppp multilink multi-class

Multilink PPP Commands
8-120 Configuring the Point-to-Point Protocol
Syntax
multilink load-threshold number (1-255)
Default
255
Mode
DialerInterfaceconfiguration:XSR(config-if<xx>)#
Example
ThefollowingexamplesetsthemultilinkPPPloadthresholdto250ontheterminatingDialer
interface:
XSR(config)#interface dialer 4
XSR(config-<D4>)#multilink load-threshold 250
ppp multilink multi-class
ThiscommandenablesMulti‐ClassMLPPP(MultilinkPPP)fortheMultilinkPPPheaderformat
providingQualityofService(QoS)forselectedpacketsbetweenpeers.Itsupportsfivestreamsof
sequencenumbers,thelongsequenceformatbydefault,andtheshortsequencenumberby
negotiation.Anyclasslowerthanthedefaultrequestedbythepeerwillbeaccepted,andhigher
thanthedefaultwilleventuallytriggerarejectmessageifthevalueisacceptedbythepeer.
Syntax
ppp multilink multi-class
Syntax of the “no” Form
Thenoformofthiscommanddisablesmulti‐classMLPPP:
no ppp multilink multi-class
Defaults
• Longsequencenumber
• Acceptnegotiationforshortsequencenumber
• Acceptanysuspendable(class)levellessthanorequalto5
• Disabled
Mode
DialerorMultilinkInterfaceconfiguration:XSR(config-if<xx>)#
1-255 Loadontheport:255indicatesithasreached100%ofbandwidth.