Enterasys Networks XSR CLI ppp multilink group

Multilink PPP Commands
8-118 Configuring the Point-to-Point Protocol
Group Num: 1
LCP State: OPENED
IPCP State: OPENED
Multilink State: OPENED
Multi-Class State: OPENED
Multilink header format is LONG SEQ NUM
Class suspendable level is 5 tx classes and 5 rcv classes
Fragmentation is disabled
Bundle Size: 2
Class Level Tx: 5
Rx: 5
Max Load Threshold: 0
Bundle Tx Load Avg: 0
Bundle Rx Load Avg: 0
No Of Pck in Rx Buf Q: 0
Lowest link Speed: 1536000
Max Fragment Size: Not Set
High Pri Member link is Serial 2/0:0
……
Thefollowingexampledisplaysfragmentationsettings:
XSR# show ppp interface multilink 1 multiclass
********** MLPPP Bundle MultiClass Stats **********
Multilink 1: MLPPP is Admin Up / Oper Up
Group Num: 1
LCP State: OPENED
IPCP State: OPENED
Multilink State: OPENED
Multi-Class State: OPENED
Multilink header format is LONG SEQ NUM
Class suspendable level is 5 tx classes and 5 rcv classes
Fragmentation is disabled
Max Fragment Size is not set
ppp multilink group
ThiscommandconfiguresaPPPlinkandassignsittoorremovesitfromaspecifiedPPPMultilink
bundle.Itappliesonlytointerfacesthatcanconfigureabundleinterfaceincludingmultilink,
dialer,andISDNBRIorPRIinterfaces.
Syntax
multilink group 1 - 32767
1 - 32767 DesignationofthePPPmultilinkgroup.