Enterasys Networks XSR CLI show ip nat translations

Network Address Translation Commands
XSR CLI Reference Guide 5-189
Defaults
•Timeout:180seconds(3minutes)
•UDP‐timeout:300seconds(5minutes)
•TCP‐timeout:86,400seconds(24hours)
•ICMP‐timeout:60seconds
Example
TheexamplebelowtimesoutUDPporttranslationentriesin15minutes:
XSR(config)#ip nat translation udp-timeout 900
show ip nat translations
ThiscommanddisplaysactiveNAPTtranslations.
Syntax
show ip nat translations [interface]
Mode
EXECorGlobalconfiguration: XSR> or XSR(config)#
Sample Output
ThefollowingexampledisplaysfourstaticNATentries.Notethatexternalhostsarenottracked
forstaticNATnorareidletimes.
XSR#show ip nat translations
Interface GigabitEthernet 2
=============================================================
Num Interface-Static NAT : 4
---------------------------------------
Pro Private Host NAT Addr External Host Idle
(Local IP Addr) (Global IP Addr)
ANY 146.115.206.31 10.120.112.2 Not Tracked n/a
TCP 146.115.206.242:80 10.120.112.146:80 Not Tracked n/a
TCP 146.115.206.242:80 10.120.112.156:80 Not Tracked n/a
UDP 146.115.206.32:223 10.120.112.156:143 Not Tracked n/a
Thefollowingexampledisplaysfour���dynamicNATentrieswithassignedaddressoverloading.
NotethatfourdifferentinsidehostsappearontheoutsidewithasingleNATIPaddress
(10.10.10.2).
XSR#show ip nat translations