Enterasys Networks XSR CLI isdn disconnect

ISDN Commands
Book Title goes here 11-87
APRIorBRIportcanhaveonlyoneISDNcalling‐numberentry.ForISDNPRI,thiscommandis
intendedforusewhenthenetworkoffersbetterpricingoncallsinwhichdevicespresentthecaller
number.Whenconfigured,thecallingnumberisincludedintheoutgoingsetupmessage.
Syntax
isdn calling-number calling-number:subaddress
Syntax of the “no” Form
no isdn calling-number
Mode
BRIInterfaceconfiguration:XSR(config-if<BRI-x>)#
Example
ThefollowingexamplespecifiesacallingnumberfortheXSR:
XSR(config)#interface bri 1/0
XSR(config-if<BRI-1/0>)#isdn calling-number 5088781234
isdn disconnect
ThiscommandisusedfordebuggingpurposestotestISDNconnectivity.ItsetsupanISDNdata
calltotestcallsetupprocedureswithaCentralOfficeISDNswitchortestequipment.Itisusedto
disconnectacallbeforeautomaticdisconnectoccursin30secondsorifacallisnotdropped.
Syntax
isdn disconnect c/p channel_number
Mode
PrivilegedEXEC:XSR#
Note: There is no mechanism to mark outgoing calls with the Calling Number and Calling
Subaddress for call routing on the receiving end.
calling-number Numberofthedevicemakingtheoutgoingcall.Onlyoneentryis
allowed.
:subaddress Extensionofthephonenumber.
Note: Enter this command in Privileged EXEC, not Global configuration mode.
c/p BRIorPRIportID.
channel_number BRI:1or2,E1PRI:0to31,T1PRI:0to22.