Enterasys Networks XSR CLI ISDN BRI and PRI Commands

Book Title goes here 11-83
11
ISDN BRI and PRI Commands
Observing Syntax and Conventions
TheCLISyntaxandconventionsusethenotationdescribedinthefollowingtable.
ISDN Commands
ThefollowingsetofcommandsallowsyoutoconfigureBRI/PRIfunctionalityontheXSR.
interface bri
ThiscommandconfiguresaBRIinterfaceforeachphysicalBRIportontheBRINIMcard.When
entered,theinterface bri commandmustbefollowedbytheisdn switch-typecommandfor
BRIISDNapplications,ortheleased-line bricommandforBRIleasedlineapplications.Ifnone
oftheabovecommandsareissuedBRIportsarenon‐operational.
Syntax
interface bri board/slot/port
Convention Description
xyz Key word or mandatory parameters (bold)
[x] [ ] Square brackets indicate an optional parameter (italic)
[x | y | z] [ | ] Square brackets with vertical bar indicate a choice of values
{x | y | z} { | } Braces with vertical bar indicate a choice of a required value
[x {y | z} ] [{ | } ] Combination of square brackets with braces and vertical bars indicates
a required choice of an optional parameter
(config-if<xx>)xx signifies the interface type and number; e.g., F1, G3, S2/1.0, M57, BRI-
1/1, PRI-2/1. F indicates a FastEthernet, and G a GigabitEthernet
interface.
Next Mode entries display the CLI prompt after a command is entered
soho.enterasys.com Italicized, non-syntactic text indicates either a user-specified entry or text with
special emphasis
board/slot/port BRIboard,slot,andportnumbers.Forleased‐lineapplications:1forB1
and2forB2.Sub‐portsareaddedbytheleased-line [56 | 64]
command.