Enterasys Networks XSR CLI isdn call, isdn calling-number

ISDN Commands
11-86 ISDN BRI and PRI Commands
Example
ThefollowingexamplesetstheT1controllertomakecallselectionsinascendingorder:
XSR(config)#controller t1 1/0/0
XSR(config-controller<T1-1/0:0>)#description “T1 at Acme”
XSR(config-controller<T1-1/0:0>)#framing esf
XSR(config-controller<T1-1/0:0>)#linecode b8zs
XSR(config-controller<T1-1/0:0>)#pri-group
XSR(config-controller<T1-2/1>isdn bchan-number-order ascending
isdn call
ThiscommandisusedfordebuggingpurposesonlytotestcallsetupprocedureswithaCentral
OfficeISDNswitchortestequipment.Itisautomaticallydisconnectedafter30seconds.
Syntax
isdn call c/p [board/slot/port] dialing-string [56 | 64]
Mode
PrivilegedEXEC:XSR#
Example
ThefollowingexampleinitiatesanISDNcallonBRIport2/1at56kbps:
XSR#isdn call 2/1:61712345678 56
<186>Jul 28 22:49:51 10.10.10.20 ISDN:
No Channel Available For Test Call
isdn calling-number
ThiscommandconfiguresanISDNPRIorBRIinterfacetoincludecaller‐numberintheout‐going
setupmessage.ThisbillingnumberisusedfornonFullyInitializingTerminals(FIT)outside
NorthAmericaonlybecausethe isdn spid1/2commandalreadyconfigurestheLDN.
Note: Enter this command in Privileged EXEC, not Global configuration mode.
c/p BRIorPRIportID.
dialing-string Calledphonenumberandsub‐address.
56 Callplacedat56kbpsrate.
64 Callplacedat64kbpsrate.